This easy clean shower trap has a removable waste grid to enable easy maintenance of the shower tray.Unlike most shower traps, it has a 50mm seal to minimise the possibility of trap seal loss as a result of siphonage.To connect the outlet of the trap to the waste pipe, unscrew the nut from the trap and remove it along with the washer and the rubber seal. Place these three components over the end of the pipe andndash; first the nut, then the washer followed by the seal. Push the pipe into the trap as far as it will go, slide the seal and washer forward into position and tighten the nut.The joint can be taken apart again if required, but always check that the rubber seal has not been damaged in any way as this will cause the joint to leak.Click here to watch our video showing how to install a trap.